User Tools

Site Tools


dig:smd

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

dig:smd [2013/03/10 16:42]
tobi [Step 1: Getting Started with the 5V rail and the PWR LED]
dig:smd [2013/03/10 16:48] (current)
tobi [Step 1: Getting Started with the 5V rail and the PWR LED]
Line 54: Line 54:
   - Be careful not to melt the plastic of the micro USB connector.    - Be careful not to melt the plastic of the micro USB connector. 
   - Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed!   - Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed!
-  - Below is an example of a micro USB header that is not properly soldered. Note how the left pin is not soldered. +  - Below is an example of a micro USB header that is **not** properly soldered. Note how the left pin is not soldered. 
  
 {{:dig:badusbsoldering.jpg?400|badly soldered micro USB header}} {{:dig:badusbsoldering.jpg?400|badly soldered micro USB header}}
dig/smd.txt · Last modified: 2013/03/10 16:48 by tobi