User Tools

Site Tools


dig:lab_4_ardu

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

dig:lab_4_ardu [2016/03/13 18:00]
tobi [Schematics Instructions]
dig:lab_4_ardu [2016/03/13 18:01] (current)
tobi
Line 28: Line 28:
 ---- ----
  
-When you are finished with your board schematic, zip your design and send it to [[tobi@ini.phys.ethz.ch?subject=micboard schematic for Electronics for Physicists II]]+When you are finished with your board schematic, zip your design and send it to [[kiselev@ini.uzh.ch?subject=micboard schematic for Electronics for Physicists II]]
  
  
Line 62: Line 62:
 {{dig:lab4_pcb_template.png ? 200px|template board layout}} {{dig:lab4_pcb_template.png ? 200px|template board layout}}
  
-When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[tobi@ini.phys.ethz.ch?subject=micboard design for Electronics for Physicists II]]+When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[kiselev@ini.uzh.ch?subject=micboard design for Electronics for Physicists II]]
  
 Here you have a screenshot of a possible solution (done using Eagle) that uses 2 layers. Polygons have been used for GND (bottom) and 3.3v (top). Here you have a screenshot of a possible solution (done using Eagle) that uses 2 layers. Polygons have been used for GND (bottom) and 3.3v (top).
dig/lab_4_ardu.txt · Last modified: 2016/03/13 18:01 by tobi